- What you need is exactly what you get
With EnergyLogic, our waste oil heaters come complete, which means there are no hidden costs or additional parts to buy. Everything it takes to heat with use doil comes standard.
- 1 Accutemp Preheater
- 2 Integrated Air Compressor
- 3 Flame Retention Head
- 4 Swing Away Burner
- 5 Stainless Steel Heat Exchanger
- 6 Squirrel Cage Blower
- 7 Easy Access Cleaning Cap
- 8 Adjustable Louvers
- 9 Steadyflo Metering Fuel Pump
- 10 Low-Fuel Cutoff
- 11 Fuel Gauge
- 12 Drain Valve
- 13 Spin-on Waste Oil Filter
- 14 Elevated Fuel Pick Up
(1) Accutemp Preheater
Used oil must be preheated prior to combustion. Our patented preheater rapidly heats the blended viscosities of crankcase oil, synthetic oil and other acceptable fuels to a precise temperature. Incorporating our high output low amp draw PTC technology combined in a large volume aluminum housing means we can heat the coldest oil and have a reserve preheated and ready to go. Annual cleaning is as fast and simple as it gets.
(2) Integrated Air Compressor
All of our furnaces come with a built-in air compressor. That means you don’t have to worry about installing additional airlines, having the capacity to run your tools and furnace at the same time, have the compressor available 24/7 to run your heater and, finally, no worries about having wet shop air enter your burner and creating light-off issues. Our small but powerful air compressor is built to last and is field serviceable.
(3) Flame Retention Head
By holding the flame stable, our patented flame retention head creates a hotter flame for complete fuel combustion. What does that mean? Less ash, longer maintenance intervals and higher heat output. If you already have a waste oil heater, look at the ash. If it is fine and white like baby powder you have good combustion. If it's grey, brown or oily, you have poor combustion and it is working a lot harder than it should to heat your building.
(5) Stainless Steel Heat Exchanger
Made of special stainless steel alloys, our heat exchanger is lighter, more durable and more corrosion resistant than the competition, and it has a longer life. It also heats up faster, allowing for continuous use at nearly twice the temperature of most models. Last but not least, its streamline design makes cleaning easy and fast. We are the only company that uses stainless steel in all of their heat exchangers and after 25 years, we have proven they will outlast other alloys.
(7) Easy Access Cleaning Cap
The cleaning cap is released by removing two screws. Any ash in the heat exchanger can be pushed to this point where it is typically gathered in a plastic garbage bag and can be disposed of with normal trash. No vacuuming, no climbing halfway in the furnace and you can count your cleaning time--typically once a year--in minutes, not hours.
(8) Adjustable Louvers
All of our furnaces come with standard louvers that direct the air up or down. They can be moved to the opposite side of the cabinet or a second set can be added so hot air comes out both sides of the furnace. Our adjustable louvers can be added to the existing set of louvers to allow air to be directed side to side, in addition to up and down.
(9) Steadyflo Metering Fuel Pump
Our Steadyflo metering fuel pump delivers the precise volume of fuel to the burner regardless of viscosity. There are no adjustments ever required as the patented gear set always measures and delivers the correct amount of fuel. That's why we can reliably burn from 5 to 90 weight oil and pump your used oil fuel anywhere in your facility.
